Directional Valves — HyPerformance

HPD42-S63 — Piloted, 4-Way, Spool-Type Valve
  Selection guide - similar valves.
  PDF file of this page
  Request a quote

HPD42-S63 Valve

HPD42-S63 Valve symbol

A high pressure, screw-in, cartridge-style, pilot-operated, 4-way, spool-type, hydraulic directional

In neutral position, the HPD42-S63 blocks flow at all ports. On remote pilot signal at 1, the valve
shifts to allow flow between ports 2 and 3, and between 4 and 5.
The spring chamber is vented to the tank through port 6. The vented spring chamber allows the
valve to be fully pressurized at ports 1, 2, 3, 4 and 5 without affecting required pilot pressure. Pressure at 6 will affect required pilot pressure at a 1:1 ratio.

• Hardened spool and cage for long life.
• Optional sealed spool between ports 1 and 2.
• All HyPerformance™ products are tested to the rigorous standards of the NFPA specification
  T2.6.1 and are tested at a verification level of 90% and an assurance of 99%.

Operating Pressure: 350 bar (5075 psi); 10% cycle life: 420 bar (6090 psi)
   Note: All HyPerformance™ products are tested for 900K cycles at 350 bar and 100K at 420 bar
Proof Pressure: 690 bar (10000 psi)
Burst Pressure: 1380 bar (20000 psi)
Flow: 189 lpm (50 gpm)
Maximum Internal Leakage: at 350 bar (5075 psi) with 32 cSt oil:
   Ports 3 to 4: 740 ml/minute (45 cu. in./minute)
   Ports 3 to 2: 370 ml/minute (23 cu. in./minute)
Temperature: -40° to 100°C (-40° to 212°F) with Buna N seals;
   -26° to 204°C (-15° to 400°F) with Viton seals;
   -54° to 107°C (-65° to 225°F) with standard PPDI Urethane seals
Filtration: See page 9.010.1
Fluids: Mineral-based or synthetics with lubricating properties at viscosities of
   7.4 to 420 cSt (50 to 2000 sus); See Temperature and Oil Viscosity, page 9.060.1
Installation: No restrictions; See page 9.020.1
Cavity: HVC42-S6; See page 9.116.1_6w
Cavity Tool: HCT42-S6xx; See page 8.600.1
Seal Kit: HSK42-S6x-BMMMM (Buna N); See page 8.650.1


HPD42-S63 Valve Performance Chart

HPD42-S63 Valve Dimensions


Cartridge: Weight: 2.0 kg. (4.3 lbs.);
Steel with hardened work surfaces.
Zinc-plated exposed surfaces; Buna N O-rings and polyester elastomer back-ups standard.

Ported Body: Weight: 16.61 kg.
(36.62 lbs.); H-series ductile iron standard. Rated to 345 bar
(5000 psi). See page 8.042.1_6w.

HPD42-S63 Ordering Chart

Selection guide - similar valves.
PDF file of this page. Request a quote.