Standard plastic knob kits feature very low effort adjustments and infinite positioning.
1.) Install the cartridge and optional lock-down plate as indicated.
See cartridge torque specifications in the Technical Data section, page 9.020.1
2.) Rotate the knob to the Start position by turning the shaft to alignment with the stamped screw.
3.) Install the knob on the stem and align the Allen head set screw with the flat surface on the stem and tighten the set screw.
4.) Peel the adhesive from the inlay and install it as desired. (Note that the inlay will be very difficult to re-position, so be careful.)
|
