Electronic Vehicle Controls - Valve Drivers - Timing/Transmission Applications

ETDR-0101A

Plug-in style, single output valve driver, transmission applications

Overview

Description

A compact plug-in style, microprocessor-based valve driver designed for use in hydraulic proportional valve applications for clutch engagement, "hot shot" coil saver and soft start motor applications. It can also operate in timer-based applications (no input or input only to start a timer). TheETDR-0101A drives a single coil to a user-defined timing profile using a digital trigger. The profile provides a stepped output which you configure with HF-Impulse: an easy-to-use software tool available as a free download atwww.hydraforce.com/electronics. An LED output indicator is located on the front.

Operation

The controller uses a digital input to start the timing sequence. As the time progresses, the output follows the defined metering profile, allowing optimum system response. You can configure six distinct time periods with corresponding output currents. The driver can apply a ramping rate when the digital input is turned off. Built-in diagnostics detect fault conditions that automatically deactivate the output. The controller has an LED output indicator.

Diagnostic Features

  • Any input below 8.5 Vdc causes the controller to default to safe mode (valve off).
  • The driver output drops and holds at the inactive stand-by condition. Any short or open circuit condition is automatically detected as an error. When the fault is corrected, the controller returns to standard operation.

Multiple Personalities

The EVDR controller is available in multiple configurations (personalities) to suit the needs of specialized applications. Choose the one that best fits your needs

EVDR-0101A - General Purpose

ETDR-0101A - Transmission Apps

EGDR-0101A - Generator Control

Ratings

Electrical Parameters
Power requirements
9 to 32 Vdc
Output current
50 to 2000 mA Continuous
3000 mA For one sec.
Processor and Memory
Processor
ARM 32-bit Cortex™-M0 CPU, 48 MHz
Flash memory
32 kB
RAM
4 kB
Properties
Mating connectors
Deutsch DT06-4S Input
DT04-2P Output
Output indicator
Red LED
Environmental rating
IP69K
Weight
0.079 kg (0.175 lb) without connectors

I/O

Control Input
Digital
Switch to battery
Switch to ground
Control Output
Current
50 to 2000 mA
PWM
0 to 100% Duty cycle
PWM frequency range
40 to 400 Hz

Configuration Example

ETDR-0101A_Config

Dimensions

ETDR-0101A_Dim ETDR-0101A_Wiring

To Order

Single Valve Driver Model ETDR-0101A: Part No. 4204810 (NOTE: If purchasing the ETDR-0101A for the first time, we suggest purchasing both the USB-TTL programming adapter and the test harness)

Configuration Software for ETDR-0101A — HF-Impulse: Free download from www.hydraforce.com/electronics.

Mating Connector Kit — DT06-4S: Part No. 4001953

Mating Connector Kit — DT04-2P: Part No. 4001958 (For remote installation)

USB-TTL Programming Adapter: Part No. 4000285

Test Harness: Part No. 4000286 (For testing and bench operation)