Directional Valves — HyPerformance

HCV06-20 — Check Valve
  Selection guide - similar valves.
  PDF file of this page
  Request a quote

HCV08-20 Valve

HCV08-20 Valve symbol

A screw-in, cartridge-style, hydraulic check valve for use as a blocking or load-holding device
for high pressure applications.

The HCV06-20 allows flow passage from 1 to 2, while normally blocking oil flow in the opposite
direction. The cartridge has a fully guided poppet which is spring-biased closed until sufficient
pressure is applied at 1 to open to 2.

• Hardened seat for long life and low leakage.
• All HyPerformance products are tested to the rigorous standards of the NFPA specification T2.6.1.
• All HyPerformance valves are tested at a verification level of 90% and an assurance of 99%.

Operating Pressure: 350 bar (5075 psi); 10% cycle life: 420 bar (6090 psi)
  Note: All HyPerformance products are tested for 900K cycles at 350 bar and 100K at 420 bar.
Proof Pressure: 630 bar (10000 psi)
Burst Pressure: 1380 bar (20000 psi)
Flow: 19 lpm (5 gpm)
Internal Leakage: 0.10 ml/minute (2 drops/minute) max. at 350 bar (5075 psi)
Temperature: -40° to 100°C (-40° to 212°F) with Buna seals;
  -26° to 204°C (-15° to 400°F) with Fluorocarbon seals
  -54° to 107°C (-65° to 225°F) with Urethane seals
Filtration: See page 9.010.1
Fluids: Mineral-based or synthetics with lubricating properties at viscosities of
  7.4 to 420 cSt (50 to 2000 sus); See Temperature and Oil Viscosity, page 9.060.1
Installation: No restrictions; See page 9.020.1
Cavity: HVC06-2; See page 9.106.1_2w
Cavity Tool: HCT06-2xx; See page 8.600.1
Seal Kit: SK06-2U-0; See page 8.650.1


HCV08-20 Valve Performance Chart


HCV08-20 Valve Dimensions


Cartridge: Weight: 0.03 kg. (0.06 lbs.);
Steel with hardened work surfaces.
Zinc-plated exposed surfaces; PPDI Urethane seals without back-up rings standard.

HCV08-20 Ordering Chart

Selection guide - similar valves.
PDF file of this page. Request a quote.